Apple Watch Ultra model has been opened!

Apple introduced its new smartphones, watches and headset models at the event it held earlier this month. The device that attracted the most attention was the Apple Watch Ultra, which was sold at a price as high as a new iPhone model in our country. Today, the inside of the device was opened and its complex structure was revealed.

Apple Watch Ultra is much more difficult to repair than other models!

Today, 9to5mac editor Derek Wise, succumbing to his curiosity, opened the inside of the Apple Watch Ultra. Wise, who expected this watch to be repaired like the other members of the series, the Apple Watch 8 and Apple Watch SE, or its predecessors, could not find what he expected.

Apple Watch Ultra is not repaired by removing the screen, as in other smartwatch models and phones of the company. Instead, it is necessary to unscrew the 4 P5 pentalobe screws (the same ones used on the M2 MacBook Air) on the back of the device.

We eliminated Ultra! Apple Watch 8 vs Apple Watch SE (2022)

We compared the Apple Watch 8 and Apple Watch SE 2022 models for people who want to buy a smart watch within the Apple ecosystem.

But Wise, who does this, sees that Apple uses o-rings on this device as an extra waterproof measure, which will cause trouble during assembly. After the screws are removed, the back cover of the device is separated with plastic apparatus, just like removing a screen. At this point, he realizes that the cover is integrated with the sensors and is connected to the clock with 2 thin cables, and carefully disconnects the connections.

However, it is also stated that the special adhesive between the back cover and the watch is likely to be damaged during this time and the waterproof feature of the device has lost its reliability. Therefore, it is recommended to clean and renew this material during the joining process.

After separating the back cover, he encounters the landscape in the image above. In other words, he realizes that the watch is only able to separate the part where the sensors are located and that he has to remove the metal protection cover by unscrewing 3 more screws in order to access the other parts.

Of course, at the same time, it is said that 3 of the 4 springs in the mechanism holding the straps of the watch jumped out of their places and this creates difficulties when putting them back together. But that’s all the action is. It is stated that there is more than one ribbon cable under the metal protection cover and there is no way to do it without looking at a diagram beforehand, and if it is tried, the watch may be permanently damaged.

Therefore, we can say that it would make more sense to repeat these steps when a repair kit of iFixit is available for sale and the repair manual is published. On the other hand, Wise says that when the watch is reassembled, the o-rings on the outermost part of the device pop out as in the image above and are not installed properly. He also describes this device as impossible to repair for now.

What do you think about this subject? Don’t forget to share your views with us in the comments!

source site-28